Need to replace your water ski boot laces or upgrade your set-up? Take a look at the Radar Lace Lock Replacement Kit. In this how-to, we walk you through step by step how to replace your water ski boot laces using the Radar Lace Lock Replacement Kit. This kit replaces most water ski boot laces.
Items You Need:
- Radar Lace Lock Kit
- Your old water ski boots
- Knife
- Lighter
Steps:
- Starting with the top laces, cut and remove your old laces paying close attention to how they are currently laced
- Re-lace using the thicker bungee type laces
- Once completed, grab the bigger pull lock section and thread laces through
- Tie knot at the end to your desired length and cut off excess
- Burn the ends once cut to prevent freying
- Moving on to the bottom laces, cut and unlace them just like you did for the top
- Re-lace using skinny, non-stretching lace.
- Grab the smaller pull section and thread laces through
- Grab the tab once threaded through and click it into the pull section
- Tie a knot in the laces at your desired laces and cut them
- Burn the ends once cut to prevent them from freying